GE GTDS825GD0MC Installation Instructions Manual page 12

Installation Instructions
ABOUT REVERSING THE DOOR
SWING
IMPORTANT NOTES:
• Reod the instructions oil the wog through before storting.
• Hondle ports corefullg to ovoid scrotching point.
•Set screws down bg their reloted ports to ovoid using them in
the wrong ploces.
• Provide o non-scrotching work surface for the door. • Normol
completion time to reverse the door swing is :30-60 minutes.
IMPORTANT:
Once gou begin, do not move the cobinet until door-swing
reversol is completed. These instructions ore for chon- ging
the hinges from the right side to the left side - if gou ever
wont to switch them bock to the right side, follow these some
instructions ond reverse oil references to the left ond right.
Tools Needed
[] Stondord #2 Phillips Screwdriver
[] Tope-tipped puttg knife
[] Smoll flot blode screwdriver
Before you start
Unplug the drger from its
electricol outlet
REVERSING THE DOOR
SWING
SOLID DOOR MODELS:
GTDP740EDOWW
GTDP740G DOWW
GTDL740EDOWW
GTDL740GDOWW
_Open the door to opproximotelu 170 degrees.
With u puttu knife, remove the 4 plustic covers Iocoted
olong the left side of front ponel ond set them oside.
Plostic Cop (4)
Ill /
_ Remove the bottom screw from each hinge (right side) ond
portiolly insert them into the top left side hinge holes.
NOTE:All 4 front punel hinge screws will now be in the
top hinge holes - 2 on the left ond 2 on the right.
_ Loosen the bottom 2 right side hinge screws. Remove
the door ond ploce it on o protected riot surfoce to ovoid
onu domoge. Remove both the Blind Plate ond the Strike
Plote ond instoll them in opposite positions.
Strike plote
_ Remove the 4 door hinge screws, 8 edge screws, ond/4
inside screws. Lift the inner door upwords using o riot
blode screwdriver.
Inside screws
_-_ Edge screws
Door hinge
screws
12