Engine Run Time; Turbo Mode; Siren Chirps - Directed Electronics ProStart CT-5472TW User Manual

Two­-way 6­-button lcd automatic/manual transmission remote starter system with full alarm system
Table of Contents

Advertisement

Safe start enabled: If this feature is enabled, the user must press the
3 seconds to remote-start the vehicle.
Swap start: If this feature is enabled;
1.
Press the
2.
The remote will beep once and
3.
Press
to remote start the vehicle.
The AUX 2 output can be activated by pressing the
Engine Run Time 
If you have a gas engine, your Remote Car Starter can be programmed to run the engine for 3, 15,
or 25 minutes (15 minutes by default). If you have a diesel engine, the Remote Car Starter can be
programmed to run the engine for 8, 20, or 30 minutes (20 minutes default).
Turbo Mode 
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine.
If your vehicle has an automatic transmission, proceed as follows to set the system to Turbo
Mode:
1.
With the engine running, make sure to release the brake pedal and press the
or
button on the transmitter until the parking lights come ON.
Note: SmartStart™ can be setup to use the SmartStart™ icon to activate Turbo mode.
2.
Remove the ignition key from the ignition switch.
The engine will continue running.
3.
Exit the vehicle and close all doors, hood and trunk.
4.
Press the
vehicle is in Turbo Mode.
5.
The engine will shut down after 60 seconds.
If your vehicle has a manual transmission, follow all steps of the Ready Mode routine (page 6) to
activate Turbo Mode. At the last step,
Press
The parking lights will flash 3 times and remain lit.
The alarm and starter kill will be armed.
Press
The parking lights will flash 3 times and remain lit.
Press
Note: The vehicle will enter Ready Mode once the engine run time expires.
Siren Chirps 
The siren will chirp to confirm the system's basic operations:
By default, when the doors are being locked, the siren will give 1 chirp if all the doors,
the hood and the trunk are closed.
If one of the doors, the hood or the trunk is open as the doors are being locked, the
siren will chirp 3 times.
When the doors are being unlocked, the siren will give 2 chirps if no intrusion was
detected.
User guide
for 1 second and release.
button; this will lock the doors, arm the system alarm and confirm that the
to lock the doors and have the engine shut down after 60 seconds;
to unlock the doors and have the engine shut down after 60 seconds;
To shut down the engine without affecting the doors.
will appear on the display.
button.
button twice within
,
P.13

Advertisement

Table of Contents
loading

Table of Contents