Table of Contents
Advertisement
Quick Links
M A N U A L / A U T O M A T I C T R A N S M I S S I O N M U L T I - C H A N N E L
R E M O T E S T A R T E R S Y S T E M
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the
device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (EIRP) is not more than that required for successful
communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the equipment.
Doc#: 111014
CT-3271
User Guide
It is the responsibility of the vehicle operator to ensure their vehicle
is parked in a safe and responsible manner.
1. a) Manual transmission: When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in the NEUTRAL
position and the parking brake is engaged in order to avoid accidents
upon remote starting.
b) Automatic transmission: When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in "Park" in order to
avoid accidents upon remote starting.
(Note: Make sure that the automatic vehicle cannot start in "Drive".)
2. It is the user's responsibility to ensure that the remote starter is
disabled or put into valet mode before servicing.
Designed & engineered in Canada
Rev: 1.2
© 2011
WARNING!
CT-3271
- CP -
Canada
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Directed Electronics CT-3271
Summary of Contents for Directed Electronics CT-3271
- Page 1 M A N U A L / A U T O M A T I C T R A N S M I S S I O N M U L T I - C H A N N E L R E M O T E S T A R T E R S Y S T E M CT-3271 User Guide...
-
Page 2: Table Of Contents
Table of Contents GOVERNMENT REGULATIONS ....................... 3 INTRODUCTION WITH SMARTSTART™ ................3 USING THE REMOTE CONTROL ..................... 4 VEHICLE PRESETS .......................... 4 Heater ............................4 Windshield Wipers, Radio & Headlights ..................4 REMOTE-STARTING YOUR VEHICLE ..................... 4 ... -
Page 3: Government Regulations
Government regulations This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. -
Page 4: Using The Remote Control
Using the Remote Control Your Remote Car Starter is equipped with a 2-button multi-channel remote control that can be configured into 2 different functions. Default remote function: • button: STOP; • button: START; • & buttons (together): TRUNK release. Alternate programmable remote function: •... -
Page 5: Remote-Starting
To set the system to Ready Mode: If Ready Mode is enabled by remote If Ready Mode is enabled by handbrake 1. Ensure that all the doors, hood and trunk are closed. Make sure that the gear selector is in the neutral position. -
Page 6: Arming And Disarming The Starter Kill (If Installed)
Note: On some Push-To-Start (PTS) vehicles, no takeover is possible as pressing the brakes will shut the engine down. Please talk to your technician to determine if the “Takeover mode” can be set for your vehicle. Arming and disarming the starter kill (if installed) This added security feature will prevent the vehicle from starting with the Ignition key when the starter kill is armed. -
Page 7: Remote Starter Features
Remote Starter Features Remote Door Locks Note: This feature is only available if button is programmed as LOCK or UNLOCK. If your system was installed with the Remote Door Locks option, you will have the convenience of remote keyless entry. To LOCK your doors and ARM the system (if installed): Press and hold the button for approx. -
Page 8: Valet Mode
Push-To-Start Idle Mode This feature is a variation of “Idle mode”, but made specifically for Push-To-Start vehicles, with automatic or manual transmissions. (Consult your installer for availability of this feature.) Follow the same steps as the normal Idle Mode procedure, except for when re-entering the vehicle while the engine is running;... -
Page 9: Panic Mode
• was programmed as LOCK & UNLOCK by your installer, press and hold the button for at least 3 seconds until the parking lights will flash for 2 seconds, pause, and then flash 3 times. To exit Cold Weather Mode, do any one of the following actions: Open the hood. -
Page 10: Secure Lock
Secure Lock (Disabled by default.) Before your vehicle can be remote-started, the factory security system must first be disarmed. The Secure Lock feature may be required on certain vehicle models with factory security systems that automatically unlock the doors when the security system is disarmed. To keep your vehicle protected when the factory security system is disarmed for a remote start, Secure Lock will relock your doors as soon as the vehicle is started. -
Page 11: Horn Confirmation
Horn Confirmation Note: Horn confirmation can be activated only if is programmed as a LOCK or UNLOCK button. If configured at installation, the horn will honk every time the doors are locked by pressing Poor Transmitting Range Issues Many factors may affect the operating range of the transmitter. Some of these are: •... -
Page 12: Diagnostics - Parking Light Flash Table
Diagnostics – Parking Light Flash Table Parking lights flashes Description • Doors locked. • Trunk released. • Start signal received from the remote. • Runtime has expired. • Doors unlocked. 2 fast • Valet mode is deactivated. • 2 slow Shutdown by remote. • 3 slow Runtime is extended. -
Page 13: Prostart Limited Lifetime Warranty
PROSTART LIMITED LIFETIME WARRANTY REMOTE STARTERS: As the manufacturer, DIRECTED ELECTRONICS, CANADA INC. (“Directed”) warrants to the original consumer purchaser only (non-transferable) that the remote starter module (control box) shall be free from defects in materials and workmanship for as long as the original consumer purchaser continuously owns the vehicle in which the remote starter was originally installed, as...
Need help?
Do you have a question about the CT-3271 and is the answer not in the manual?
Questions and answers