ProStart CT-5072 User Manual

One-way automatic/manual transmission remote starter with full alarm system and virtual tach system
Hide thumbs Also See for CT-5072:

Advertisement

O N E - W A Y A U T O M A T I C / M A N U A L T R A N S M I S S I O N
R E M O T E S T A R T E R W I T H F U L L A L A R M S Y S T E M
INDUSTRY CANADA USER NOTICE:
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired operation of the
device.
To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that
the equivalent isotropically radiated power (EIRP) is not more than that required for successful
communication.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the equipment.
Doc#: 110906
A N D V I R T U A L T A C H S Y S T E M
( A S P R G - 1 0 0 0 C O M P A T I B L E )
CT-5072
User Guide
It is the responsibility of the vehicle operator to ensure that their
vehicle is parked in a safe and responsible manner.
1. a) Manual transmission: When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in the NEUTRAL
position and the parking brake is engaged in order to avoid accidents
upon remote starting.
b) Automatic transmission: When leaving the vehicle, it is the user's
responsibility to ensure that the gearshift lever is in "Park" in order to
avoid accidents upon remote starting.
(Note: Make sure that the automatic vehicle cannot start in "Drive".)
2. It is the user's responsibility to ensure that the remote starter is
disabled or put into valet mode before servicing.
Rev:1.4
© 2011
WARNING !
-CT-5072-
-FcN-
Canada

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CT-5072 and is the answer not in the manual?

Questions and answers

Summary of Contents for ProStart CT-5072

  • Page 1 A N D V I R T U A L T A C H S Y S T E M ( A S P R G - 1 0 0 0 C O M P A T I B L E ) CT-5072 User Guide...
  • Page 2: Table Of Contents

    ..................12   HOCK ENSE ENSE : ..........................12   RIORITY DOOR ......................... 12   ULTI PERATION DIAGNOSTICS – PARKING LIGHT FLASH TABLE ..............13   POOR TRANSMITTING RANGE ISSUES..................13   PROSTART LIMITED LIFETIME WARRANTY ................14   User Guide...
  • Page 3: Introduction With Smartstart

    Introduction with SmartStart™    This is a state-of-the-art remote car starter system. The system is packed with advanced features such as priority access to the driver’s door (commodity features), the Safe Start children safety feature and SmartStart™. SmartStart™ is a groundbreaking technology that enables your remote starter features to be accessed by your smartphone.
  • Page 4: Vehicle Presets

    Vehicle Presets  Heater  When leaving the vehicle it is recommended to preset the accessory controls in preparation for the next remote start. Settings for the blower motor (fan), front and rear, should not be left on HIGH. It is recommended to leave the settings on LOW or MEDIUM instead. Windshield Wipers, Radio & Headlights ...
  • Page 5: Remote­starting

    WARNING: Engine runs until the pre-programmed run time expires. 6. The Parking lights will flash twice to indicate Ready mode is set. Remote­starting  Press the button for approximately 1 second. The parking lights will turn ON to inform you that the Remote Car Starter has received your signal.
  • Page 6: Remote Starter Features

    The LED on the antenna will remain OFF. Remote Starter Features  Remote Door Locks  If your system was installed with the Remote Door Locks option, you will have the convenience of remote keyless entry. To UNLOCK your doors and DISARM the system: Press and hold the button for approx.
  • Page 7: Valet Mode

    Note1: The engine will continue running until the user re-enters the vehicle or until the expiration of the run time. Note2: If the pre-programmed run-time expires or if the user shuts down the engine remotely, the vehicle will enter Ready Mode automatically (manual transmissions only). Caution!!! Do not leave children or pets unattended in a vehicle standing in Idle Mode.
  • Page 8: Panic Mode

    Turn the key to the ON position. Press the push-button switch until the Parking lights flash twice. Release the push-button and turn the ignition to the OFF position. The LED on the antenna will switch OFF indicating that the vehicle is now out of Valet mode. If someone attempted to remote-start the vehicle while in Valet Mode;...
  • Page 9: Extended Run Time

    Extended Run Time  This procedure can only be carried out once per remote start. While the vehicle is running remotely, pressing and releasing the button for 1 second will reset the run time counter to zero and restart the run time cycle from the beginning. The siren will sound and the parking lights will flash slowly 3 times then remain lit.
  • Page 10: Advanced Features: Installation-Programmable Options

    Advanced Features: Installation­programmable Options  The Remote Car Starter was designed with flexibility and OEM integration in mind. With its programmable options, this unit can single-handedly control nearly any electrical system in your vehicle. Caution: The programming of your system should be left to a professional. Changing any one of the settings may affect the operation of your Remote Car Starter.
  • Page 11: Siren Chirps

    Exit the vehicle and close all doors, hood and trunk. Press the button; this will lock the doors, arm the system alarm and confirm that the vehicle is in Turbo Mode. The engine will shut down after 60 seconds. If your vehicle has a manual transmission, follow all steps of the Ready Mode routine (page-4) to activate Turbo Mode.
  • Page 12: Shock Sense And Warn -Away Sense

    Siren to sound once after 10 sec. to warn the user that the vehicle was left unprotected. Pressing will cancel this timer. Shock Sense And Warn­Away Sense  If somebody hits, jostles or otherwise moves your car, the shock sensor sends a signal to the brain indicating the intensity of the motion.
  • Page 13: Diagnostics - Parking Light Flash Table

    Diagnostics – Parking Light Flash Table  Parking lights flashes Description • Doors locked. • Trunk released. • Start signal received from the remote. • Runtime has expired • Doors unlocked 2 fast • Valet mode is deactivated • 2 slow Shutdown by remote • Shutdown by brake 4 fast •...
  • Page 14: Prostart Limited Lifetime Warranty

    (only) and a copy of the proof of purchase, freight prepaid, along with their name, address and telephone number, to the PROSTART SERVICE CENTER for the exchange to take place. MODULES RETURNED TO THE POINT OF PURCHASE AFTER THE ONE-YEAR REPLACEMENT PERIOD WILL NOT BE ACCEPTED. A module will be returned to the consumer, freight collect, within 4 weeks of receipt of the module.

Table of Contents

Save PDF