Step 15 Connect Power Supply; Step 16 Pretest Check List - GE PDW8100 Series Installation Instructions Manual

Installation instructions
STEP 15 CONNECT POWER
SUPPLY
Skip this step if equipped with power cord.
Proceed to step 16.
Verify that power is turned off at the source.
, Remove junction box cover "A".
=Secure house wiring to the back of the junction box
with a strain relief "B".
, Locate the three dishwasher wires, (white, black and
green) with stripped ends. Insert dishwasher wires
through the small hole in the junction box "C'. Use
wire nuts to connect incoming ground to green,
white to white and black to black "D".
, Replace junction box cover "A'. Check to be sure
that wires are not pinched under the cover.
A
Remove
Junction Box
Cover
S
InsertPower:,, _,_,_ _- )
C°sr_r a_'rt_s, _hrL_. ` __
J
andTighten I _ i
, ite
Ground _ __Black
C CheckThatWhite. Blackand
GreenDishwasher Wires AreThreaded
ThruSmall Holein Bracket
E Replace Junction Box Cover
D
UseULListed
Wire Nuts
FigureJJ
If house wiring is not 2-wire with
ground, a ground must be provided by
the installer. When house wiring is
aluminum, be sure to use UL Listed
anti-oxidant compound and aluminum-
to-copper connectors
STEP 16 PRETEST CHECK LIST
Review this list after installing your dishwasher to
avoid charges for a service call that is not covered
by your warranty.
[] Checkto be sure power is OFE
[] Open door and remove all foam and paper
packaging.
[] Locate the Owner's Manual in the literature
package.
[] Read the Owner's Manual for operating
instructions.
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
[]
Check door opening and closing. If door does not
open and close freely, check for proper routing of
spring cable over pulley. See Step 1, Figure G and
H. If door drops or closes when released, adjust
spring tension.
Check to be sure that wiring is secure under the
dishwasher, not pinched or in contact with door
springs or other components. See Steps 8 and 10.
Check door alignment with tub. If door hits tub,
level dishwasher. See Step 11.
Pull lower rack out, about halfway. Check to be
sure it does not roll back or forward on the door.
If the rack moves, adjust leveling legs. See Step 11.
Check door alignment with cabinet. If door hits
cabinet, reposition or relevel dishwasher. See
Steps 10, 11 and 12.
Check that door spring does not contact water
line, fil! hose, wiring or other components. See
Step 13.
Verify water supply and drain lines are not kinked
or in contact with other components. Contact with
motor or dishwasher frame could cause noise. See
Steps 6 and 8.
Turn on the sink hot water faucet and verify water
temperature. Incoming water temperature must
be between 120°Fand 150°E Aminimum of 120°F
temperature is required for best wash perfor-
mance. See "Prepare Hot Water Line," page 5.
Add 2 quarts of water to the bottom of the
dishwasher to lubricate the pump seal.
Turn on water supply. Check for leaks. Tighten
connections if needed.
Remove protective film if present from the control
panel and door.
11