GE PDW8100 Series Installation Instructions Manual page 10

Installation Instructions
STEP 13]CONNECT WATER SUPPLY
Connect water supply line to 90° elbow.
, Slide compression nut, then ferrule over end of
water line.
, Insert water line into 90 ° elbow.
, Slide ferrule against elbow and secure with
compression nut.
IMPORTANT - Check tobe sure that door
spring does not rub or contact the fill hose or water
supply line. Test by opening and closing the door. Re-route
the lines if a rubbing noise or interference occurs.
FigureDD
- Compression Nut ....---
Ferrule._
_\x
/
Hot Water
__ 90° Ebow SupplyLiney /
/ 90° Elbow
DoorSpring
[STEP 14] CONNECT DRAIN LiNE DRAIN LiNE iNSTALLATiON
FOLLOW ALL LOCAL CODES AND ORDINANCES.
Identify the type of drain hose you have. The molded
end of the drain hose will fit 5/8" through 1"diameter
inlet ports of the air gap, waste tee or disposer.
, Determine size of inlet port.
, Cut drain hose connector on the marked line, if
required, to fitthe inlet port.
Type I _ Cutting Line
Type 2
Cutting Lines
iMPORTANT:Do not cut corrugated
portion of hose
IMPORTANT:Do not cut corrugated
portion of hose
FigureEE
,If a longer drain hose is required, add up to 42" of length
for a total of 10' to the factory installed hose. Use 5/8" or
7/8" inside diameter hose and a coupler to connect the
two hose ends. Secure the connection with hose
clamps.
FigureFF
Hose Clamp
Coupler
Hose Clamp
,Securethe drain hose to the air gap, waste tee or
disposer with clamps.
NOTE: TOTAL DRAIN HOSE LENGTH MUST NOT EXCEED
10' FOR PROPER DRAIN OPERATION.
, Connect drain line to air gap, waste tee or disposer
using either previously determined method.
Method 1 - Air gap with waste tee or disposer
Waste Tee Instaihtion Disposer Instaihtion
FigureGG
Method 2 - "High drain loop" with waste tee or disposer
Fasten to underside
_ _ of countertep,
Waste Tee Instalhtion
Figure HH
Fasten to underside
_ f_ of countertop
32" I
Disposer Instaihtion
IMPORTANT -
When connecting drain line to dis-
poser, check to be sure that drain plug
has been removed. DISHWASHER
WILL NOT DRAIN IF PLUG IS LEFT IN PLACE.
Remove
Hopper
Plug
TiP: Avoid unnecessary service call charges. Always be
sure disposer drain plug has been removed before
attaching dishwasher drain hose to the disposer.
10