GE PDW8100 Series Installation Instructions Manual page 6

Installation instructions
[STEP 2] REMOVE WOOD BASE,
iNSTALL LEVELING LEGS
I PORTANT= oo.o,.,o.o.
wood base! Damage will occur.
= Move the dishwasher close to the installation
location and lay it on its back.
= Remove the four leveling legs on the underside of
the wood base with an adjustable
wrench or 15/16" socket.
* Discard base.
Figure J
= Screw leveling legs back into the dishwasher
frame, approximately 1/4" from frame as shown.
[STEP 3] REMOVE TOEKICK
= Remove the 2 toekick screws and toekick. Set aside
for use in Step 18.
Figure K
Remove2
ToekickScrews
[STEP 4] INSTALL POWER CORD
Skip this step if dishwasher will be direct wired or
has a factory installed power cord.
Use Power Cord Kit WX09X70910, available for
purchase from an authorized GE Appliance Dealer.
The power cord and connections must comply with
the National Electrical Code, Section 422 and/or local
codes and ordinances.
, Maximum power cord length is 6'.
A B
Remove Insert Power
Junction Box Cord Wires Thru\
Cover Strain Relief
and Tighteun_d ¢ _ Gro '
C CheckThat White, Black and ----1_'
Green Dishwasher Wires Are Threaded
Thru Small Hole in Bracket
FigureL
D
Use UL Listed
Wire Nuts
, Connect incoming power cord white
(or ribbed) to dishwasher white, black (or smooth) to
black and ground to dishwasher green wire. Use UL
listed wire nuts of appropriate size.
, Replace junction box cover. Be sure wires are not
pinched under the cover.
STEP 5 iNSTALL 90 ° ELBOW
* Wrap 90° elbow with
thread seal tape.
*Install a 90° elbow
onto the
water valve.
Front of Dishwasher
6
Valve
Bracket
go°
Elbow
FigureM
Fill
Hose
Thread
Seal Tape
* Do not over tighten the 90° elbow, water valve
bracket could bend or water valve fitting could break.
, Position the end of the elbow to face the rear of the
dishwasher.