Advertisement
Assembly (cont'd)
16
Step Five:
Lower the top of the control panel (16) on to the
upright assembly as shown below
Step Six:
Route the wire harness (8) as shown below. Pull the wire harness taut then apply tape #1 exactly as shown. Repeat and apply tape #2
exactly as shown. Harness must be flat against the side wall of the black plastic housing between tape#1 and tape #2. Plug the end of the
wire harness into the connector on the circuit board. All the slack in the wire harness should be near the connector.
Connector
10
Hide quick links:
Advertisement
