Amana AGP200VDW0 Installation Instructions Manual page 17

20" (50.8 cm) freestanding gas range with standard clean oven
Hide thumbs Also See for AGP200VDW0:
Table of Contents

Advertisement

Available languages

Available languages

1. Remove control knobs a ndsetaside.
2. Remove upper grates.
3. Liftthecooktop b yboth front c orners andhold itbythefront
center edge.
4. Open oven door.
5. Locate t hetwotopfasteners and twobottom fasteners onthe
front p anel andremove them, u sing a Phillips head
screwdriver.
A. Topfasteners
B. Bottomfasteners
A
/
6. Set the front panel aside and locate the oven thermostat.
13. Replace the front panel and screw bottom and top fasteners
in place.
14. Slowly lower the cooktop until it snaps into position. Close the
oven door.
1. Refer to the "Make Gas Connection"
section for properly
connecting the range to the gas supply.
2. Turn the manual shutoff valve in the gas supply line to the
open position.
3. Refer to the "Check Operation" section for proper burner
ignition, operation, and burner flame adjustments.
IMPORTANT: You may have to adjust the "LO" setting for
each cooktop burner.
Checking for proper cooktop and oven burner flames is very
important. The small inner cone should have a very distinct
blue flame 1/4" to 1/2" (6.4 mm to 13 mm long). The outer
cone is not as distinct as the inner cone. Natural gas flames
do not have yellow tips.
4. Close the broiler door and press the "OFF" pad.
5. Refer to the "Complete Installation" section to complete this
procedure.
..................................................................
A
J
A. Oven thermostat
7. Locate the natural gas by-pass screw in the bag containing
literature included with the range. One natural gas by-pass
screw is stamped "76".
8. Remove the LP gas by-pass screw with a flat blade
screwdriver, turning counterclockwise.
A. Pilotscrew
B. By-passscrew
9. Install the natural gas by-pass screw with a flat blade
screwdriver turning, clockwise.
10. Locate the natural gas pilot screw in the bag containing
literature included with the range. One natural gas pilot screw
is stamped "94".
11. Remove the LP gas pilot screw with a flat blade screwdriver,
turning counterclockwise.
12. Install the natural gas pilot screw with a flat blade
screwdriver, turning clockwise.
17

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cg11000vdv0Tgp200vdq0

Table of Contents