Table of Contents
Advertisement
How to fill the rinse aid and the detergent dispenser
Rinse aid
This product makes dishes sparkle and helps them to dry without spotting. The dispenser is located on
the inside panel of the door .
When the low rinse aid indicator lights, you must load rinse aid.
Loading the rinse aid
Regardless of the type of detergent dispenser installed on your
appliance, you must proceed as indicated below when loading the
rinse aid.
To open the dispenser, turn the " 1 " cap in an anti-clockwise direc-
tion and then pour in the rinse aid, making sure not to overfill. The
amount of rinse aid used for each cycle can be regulated by turning
the "2" dose adjustor, located beneath the "1" cap, with a screwdriver.
There are 6 different settings; the normal dosage setting is 2.
Important
Proper dosage of the rinse aid improves drying.
If drops of water remain on the dishes or spotting occurs, the dosage adjus-
tor should be turned to a higher setting.
If the dishes have white streaks, turn the dosage adjustor to a lower setting.
Detergent
Detergent specifically intended for use with dishwashers must be used.
The dispenser must be refilled before the start of each wash cycle
following the instructions provided in the "Programme overview". The
detergent dispenser is located on the inside panel of the door.
Loading the detergent
To open the " 3" cover on the dispenser, press the "4" button.
The detergent for the wash cycle should be poured into the " 5"
compartment.
The detergent for the pre-wash cycle should be poured into the
" 6" compartment.
After the detergent has been placed in the dispenser, close the
cover and press down until it clicks in place.
Notice:
To facilitate closing the cover, remove any excess detergent on
the edges of the dispenser.
1
4
3
6
5
2
7
Hide quick links:
Advertisement
Table of Contents
