Washing Dishes - Haier HDW101SST Instructions For Use Manual

Washing dishes

Washing dishes Washing dishes
Washing dishes Washing dishes
Programme selection Programme selection
Programme selection Programme selection Programme selection
The most appropriate programme can be identified by comparing the type of crockery, cutlery, etc., as
well as the amount and condition of food remains, with the details contained in the wash cycle table.The
corresponding programme sequence and consumption details are shown in the right half of the overview.
For example:
Use the "Heavy Wash" programme for dishes and utensils which have plenty of food remains stuck on
hard.
Earn savings Earn savings
Earn savings Earn savings Earn savings
If only a small number of dishes have been loaded into the dishwasher,selecting a programme that
operates at the next lowest temperature will usually be sufficient.
Programme data Programme data
Programme data Programme data Programme data
The stated programme data are based on standard operating conditions. The values can vary consider-
ably according to:
different amounts of dishes
temperature of mains water supply
pressure of mains water supply
ambient temperature
fluctuations in mains voltage
machine-related factors (e.g. temperature, water volume,...)
Turning on the Appliance Turning on the Appliance Turning on the Appliance
Turning on the Appliance Turning on the Appliance
Starting a wash cycle... Starting a wash cycle... Starting a wash cycle...
Starting a wash cycle... Starting a wash cycle...
Make sure that the plug for the appliance is inserted into the wall socket.
Make sure that the water supply is turned on to full pressure.
Load the dishes.
Pour in the detergent.
Press the ON-OFF button, and the "End" light will turn on.
Turn the knob located on the right of the control panel until the number or symbol for the cycle setting
is aligned with the refrence mark (see the section entitled, program overview).If the knob rightly
aligned with the refrence mark you want to choose, you must turn the knob to with the mark of
"Reset" .Then back to the number or symbol of the program you want to choose.
After five seconds the "End" light will turn off, the wash cycle will begin.
Note: Note:
Note: Note: Note:
When washing, the knob will not rotate itself.
12