Model No: DW12-PFE2-E/DW12-PFE2-U/DW12-PFE2ME-U
7. How to fill rinse aid and detergent dispenser
7-1.How to fill rinse aid
This product makes dishes sparkle and helps them to dry without
spotting. The dispenser is located on the inside panel of the door .
When the low rinse aid indicator
7-1-2.Loading the rinse aid
Regardless of the type of detergent dispenser installed on your
appliance, you must proceed as indicated below when loading the rinseaid.
To open the dispenser, turn the
and then pour in the rinse aid, making sure not to overfill. The amount
of rinse aid used for each cycle can be regulated by turning the "
dose adjustor, located beneath the
are 6 different settings; the normal dosage setting is 3.
Proper dosage of the rinse aid improves drying. If drops of water remain on the dishes
or spotting occurs, the dosage adjustor should be turned to a higher setting. If the
dishes have white streaks, turn the dosage adjustor to a lower setting.
7-2. How to fill detergent dispenser
Detergent specifically intended for use with dishwashers
must be used. The dispenser must be refilled before the start
of each wash cycle following the instructions provided in the
"Programme overview". The detergent dispenser is located
on the inside panel of the door.
7-2-2.Loading the detergent
To open the " 4 " cover on the dispenser, press the " 5 " button.
The detergent for the wash cycle should be poured into the " 6 "
The detergent for the pre-wash cycle should be poured into the " 7 " compartment.
After the detergent has been placed in the dispenser, close the cover
and press down until it clicks in place.
To facilitate closing the cover, remove any excess detergent on
lights, you must load rinse aid .
cap in an anti-clockwise direction
cap, with a screwdriver. There
the edges of the dispenser.