Star Trac E-UB Owner's Manual page 13

c) Slide the display console neck onto the neck brackets of the bike
frame.
between the console neck and the bike frame when sliding the con-
sole into place.
d) Secure the display console to the frame with four M6 X 16 flat
head screws (two screws in front side and two screws in back side).
Using the 4mm hex wrench, tighten all four screws securely.
e) Take the front display to the bike. Attach the cables from the
neck to the front display.
Plug in the 12 pin display cable from the neck into the
front display circut board at J4.
Plug in the Heart Rate cable from the handlebars into
the HR board.
Plug the HR ground into the quick disconnect tab on
the display frame.
If you are installing STAR TRAC Entertainment, Refer to the
PVS Install guide before you perform this step. If not take the Coax
and the DC Power cables and return them back down the neck.
f) Attach front display to back bysliding the bottom of the front display
under the two tabs at the base of the round bar. Press the display
against the round bar and rotate it to the back. Be careful not to
pinch any wires.
g) Secure the front display to the back with (8) m4 x 0.7 x 19mm long
Phillips Head Screws. Us a #2 Phillips head screwdriver and tighten
the screws snug to the plastic.
STAR TRAC E SERIES BIKES O
Be careful not to pinch the wires or your fingers
' G
WNER S UIDE
Ground Quick
Disconnect
Ground
J4
Wire
Heart
Rate
Board
13