Kenmore 79036693501 Installation Instructions Manual page 11

ModeBsEquipped with LeveB[ng[eBegs
Toreduce the riskoftippingof the range,
tile range mustbesecured t o thefloorbyproperly
installed anti-tipbrackets a ndscrews packed w ith the
range. T hese partsarelocated in a plastic: bagin the
oven.Failure t o install t he antPtipbrackets w ill allowthe
range to tip overif excessive weightisplaced onan
opendooror if a childclimbs uponit. Serious i njury
mightresult f romspilled hot liquids or fromtherange
itself.
Follow the instructions below to install t he antPtip
brackets.
If range isevermoved to a different l ocation, t heantPtip
brackets m ustalsobemoved andinstalled w ith the
range. T ocheck for proper installation, seestep5.
ToolsRequired:
5/16" (0,79cm)Nutdriver or FlatHead Screwdriver
Adjustable Wrench
Electric Drill
3/16"(0,5cm)Diameter DrillBit
3/16"(0,5cm)Diameter Masonry D rillBit(if installing in
concrete)
Brackets a ttach to the floorat tile backof tile range to
holdbothrearleglevelers. Whenfastening t o thefloor,
besure thatscrews d o not penetrate e lectrical wiringor
plumbing. Thescrews p rovided will workineitherwood
or concrete.
AntPtip Bracket
Back Edge of Range ¢
or Rear Wall "<_ _._.....
...-9
us"_... 18w'>\ ._'-.
'<:"/\'-.. 28 !/8"
AntPtip Bracket ""--. (71.4cm)
"-.#/(Rear width of range
with body sides)
(eL = Center line)
1. Unfold paper template and place it flat on the floor
with the back and side edges positioned exactly
where the back and sides of range will be located
when installed. (Use the diagram below to locate
brackets if template is not available. (Figure 17))
2. Mark on the floor the location of the 4 mounting
holes shown on the template. For easier installation,
3116" (0.5 cm) diameter pilot holes 1/2" (1.3 cm)
deep can be drilled into the floor.
3. Remove template and place brackets on floor with
turned up flange to tile front. Line up holes in
brackets with marks on floor and attach with 4
screws provided. Brackets must be secured to solid
floor. If attaching to concrete floor, first drill 3/16"
(0.5 cm) dia. pilot holes using a masonry drill bit.
4. Level range if necessary, by adjusting 4 leg levelers
with wrench (Figure 18). A minimum clearance of I/
8" (0.8 cm) is required between the bottom of the
range and the rear leg levelers to allow room for the
antPtip brackets.
5. Slide range into place making sure rear legs are
trapped by' ends of brackets. Range may' need to be
shifted slightly to one side as it is being pushed back
to allow rear legs to slide under brackets. You may
also grasp the top rear edge of the range and
carefully attempt to tilt it forward to make sure
range is properly anchored.
Figure 18
Figure 17
Slide Back
11