Vertex Standard VX-920 Series Operating Manual page 25

AF M V
IN R
Press the assigned programmable key to reduce the
audio output to the (lower) level programmed by your
Dealer.
Press the key again to return to the normal audio
output level.
S S
TATUS ET
Press the assigned programmable key to change the
5-Tone status code. To change the status code, se-
lect the desired digit by [ A ] key, then change the num-
ber by [ B ] / [ C ] key, and store the number by [ D ]
key.
S U /D
TATUS P OWN
Press the assigned programmable key to select a 5-
Tone status code from the pre-defined status list.
S C
TATUS HECK
Press the assigned programmable key to check the
5-Tone receive status code. When you press this key,
the LCD display will indicate the "Message" corre-
sponding to the receive status condition per the pre-
defined status list.
VX-920/-970 S O
ERIES PERATING
A O
DVANCED PERATION
L
Press the assigned programmable key to toggle the
Lone Worker feature "On" and "Off."
The Lone Worker feature is designed to emit an alarm
for 30 seconds when the Lone Worker Timer (pro-
grammed by your Dealer) has expired. If the user
does not reset the timer by pressing the PTT switch,
the radio switches to the Emergency mode.
To revive the radio from the Emergency mode, just
press the programmable key which is assigned the
Emergency feature or turn off the radio.
DTMF C
You may send the desired telephone number manually.
To dial a number manually, press the assigned pro-
grammable key, then press the desired numbers on the
front panel's numeric key. Now, press the PTT switch
to send the telephone number. The DTMF tones sent
during the dialing sequence will be heard in the speaker.
M
ANUAL
W
ONE ORKER
S
ET ( 16-
ODE
KEY VERSION ONLY
)
23