Advertisement
With dryer in final position place level on top of the dryer, first
side to sidel then front to back. if the dryer is not level, adjust
the legs of the dryer up or down until the dryer is level.
Electdcam Shock Hazard
Pmug into a grounded
3 prong outJet.
Do not remove ground
prong,
Do not use an adapter,
Do not use an extension
cord.
FaiJure to follow these instructions
can resumt in death,
fire, or e_ectricam shock,
3, Check dryer operation (some accumulated
time may be on
the timer due to factory testing).
insert coins in slide and press slide in slowly. (Operating time
will accumulate per number of coins and type of timing cam
used.) Push START/RESTART button. Using a fulI heat cycle
(not the air cycle), Jet the dryer run for at least five minutes.
Dryer wJJlstop when time is used up.
NOTE: Dryer door must be closed for dryer to operate. When
door is open, dryer stops, but timer continues to run. To
restart dryer, close door and push START/RESTART button.
4, if the burner does not ignite and you can feel no heat inside
the dryer, shut off dryer for five minutes. Check that all supply
valve controls are in "ON" position and that the electrical cord
is plugged in. Repeat five-minute test.
5, if drying time Js too long, make sure Jint screen Js clean.
2, Plug into a grounded 3 prong outlet.
iNSTALLATiON iNSTRUCTiONS-
ELECTRIC DRYER
The consob houses the factorydnstaHed accumulator timer with
actuating arm and button.
The factory-installed
timer is set to provide 45 minutes (4 pins) of
drying time when activated by the coin slide. Timer cams for
30-minute (6 pins) and 60-minute (3 pins) drying times are
included in the parts bag.
5, Start to screw the leveling legs into the holes by hand. (Use a
small amount of liquid detergent to lubricate the screw
threads so it is easier to turn the legs.) Use a 1-inch wrench or
socket wrench to finish turning the legs until you reach the
diamond mark.
6, Remove cardboard or hardboard from under dryer.
Now stand the dryer up.
NOTE: if the coin slide and coin box mechanism is installed, go
to "Adjusting Coin Box" section.
1, Remove the service door of the meter case by lifting it up at
the back. Install money-accepting
device. (Refer to
manufacturer's
instructions for proper installation.)
NOTE: Slide dryer onto cardboard or hardboard before moving to
avoid damaging floor covering.
1, Using two or more people, move dryer to desired installation
location.
2, Take tape off front corners of dryer. Open dryer and remove
the literature and parts packages. Wipe the interior of the
drum thoroughly with a damp cloth.
3, Take two of the cardboard corners from the carton and place
them on the floor in back of the dryer. Firmly grasp the body
of the dryer and gently Iay it on its back on the cardboard
corners.
4, With one of the legs in hand, check the ridges for a diamond
marking. That's how far the leg is supposed to go into the
hole.
For dryers using coin sJides, use the adapter kit supplied with
the dryer.
Replace the meter case service door. Make sure the lock is
located toward the rear of the case.
11
Advertisement
