Advertisement
DirectWireMethod
1, Disconnect power.
2, Remove hold-down screw and terminal block cover.
Fire Hazard
Use 10 gauge soJid copper
wire.
Use a UL misted strain relief.
Disconnect
power before making emectrica_ connections.
Connect
neutral wire (white or center wire) to center
terminal
(simver).
Ground wire (green or bare wire) must be connected
to
green ground
connector.
Connect
remaining
2 suppmy wires to remaining
2 termina_s (go_d).
SecureSy tighten
aH eBectrical connections.
Failure to do so can result in death, fire, or
emectrical shock.
Direct wire cable must match power supply (4-wire or 3-wire) and
be:
[]
Flexible armored cable or nonmetallic sheathed copper cable
(with ground wire), protected with flexible metallic conduit. AII
current-carrying
wires must be insulated,
[]
10-gauge solid copper wire (do not use aluminum),
[]
At least 5 ft. (1.52 m) long.
sO
/"
A. External ground conductor screw
B. Tab
C, Terrninalblock cover
D, Hold-down screw
Install ¾" conduit connector into the hole below terminal
block opening, Connect flexible metallic conduit and tighten
connector screw, Install direct wire cable through flexible
metallic conduit.
J
...... B
\
A, Conduit connector
B. Dryer cabinet
C, Connector screw
Complete installation following instructions for your type of
electrical connection:
®Four-wire (recommended method)
Three-wire (if four-wire is not available)
Direct Wire,
Four=wire electrical
connection:
to
disconnect
box
Shape ends
of wires into
a hook,
31f2' (8,9 cm)
_1
I
ofwires
|_
stripped of |
insulation
I_
5" (12.7 cm)
Strip 5" (12_7 cm) of outer covering
from end of cable, Leave bare ground
wire at 5" (12,7 cm), Cut 11f/' (3.8 cm)
from 3 remaining wires, Strip
insulation back1"(2.5cm),
A, 3/4"conduit connector
B. Neutral (white or center)
C, Ground wire (green or bare)
D, lO-gauge, 3 wire with ground wire in
flexible metallic conduit
5, Remove center terminal block screw.
6, Remove appliance ground wire (green
with yellow stripes) from external ground
conductor screw. Fasten under center,
silver-colored terminal block screw,
7, Connect the ground wire (green or bare)
of the direct wire cable to the external
ground conductor screw. Tighten screw,
8, Place the hooked end of the neutra! wire
(white or center) of direct wire cable
under the center screw of terminal block
(hook facing right). Squeeze hooked end
together, Tighten screw,
9, Place the hooked ends of the other
direct wire cable wires under the outer
terminal block screws (hook facing right),
Squeeze hooked ends together. Tighten
SCreWS.
10, Insert tab of terminal block cover into
slot of dryer rear panel Secure cover
with hold-down screw.
A.......
_._'-.....
........ ...................
'
.fj
C
D
A. External ground conductor screw
B, Appliance ground wire
C, Center terminal block screw
D. Outer terminal block screws
E. Neutral (center wire)
15
Advertisement
