Advertisement
NSTALLAT ON
NSTRUCT ONS-
GAS DRYER
i_:::i_,,'_<@l:}Sii._
@ i_iiil_ii:i!!_
iil}i_}i_,@ii
....
The console houses the factory-installed
accumulator timer with
actuating arm and button.
The factory-installed
timer is set to provide 45 minutes (4 pins) of
drying time when activated by the coin slide. Timer cams for
30-minute (6 pins) and 60-minute (3 pins) drying times are
included in the parts bag.
2. Replace the meter case service door. Make sure the lock is
located toward the rear of the case.
Adjusting
Coin
Box
The tight fit of the coin box is set at the factory. You can loosen
the fit as desired by loosening the slotted rods inside the front of
the coin box.
NOTE: Slide dryer onto cardboard or hardboard before moving to
avoid damaging floor covering.
1. Using two or more people, move dryer to desired installation
location.
2. Take tape off front corners of dryer. Open dryer and remove
the literature and parts packages. Wipe the interior of the
drum thoroughly with a damp cloth.
3. Take two of the cardboard corners from the carton and place
them on the floor in back of the dryer. Firmly grasp the body
of the dryer and gently lay it on its back on the cardboard
corners.
4. With one of the legs in hand, check the ridges for a diamond
marking. That's how far the leg is supposed to go into the
hole.
5. Start to screw the leveling legs into the holes by hand. (Use a
small amount of liquid detergent to lubricate the screw
threads so it is easier to turn the legs.) Use a 1-inch wrench or
socket wrench to finish turning the legs until you reach the
diamond mark.
6. Remove cardboard or hardboard from under dryen
Now stand the dryer up.
NOTE: If the coin slide and coin box mechanism is installed, go
to "Adjusting Coin Box" section.
1. Remove the service door of the meter case by lifting it up at
the back. Install the money-accepting
device. (Refer to
manufacturer's
instructions for proper installation.)
A. Slotted rods
NOTE: Keep a record of a!l coin box key numbers. A lost key can
only be replaced if ordered by key number from Sears Parts. The
key number is located both on the key and behind the end panel
of the coin box. If the key number is not available, the lock must
be drilled out to remove the coin box.
1. Remove red cap from gas pipe.
2. Connect gas supply to dryer. Use pipe-joint compound
resistant to the action of LP gas for gas connections. If
flexible metal tubing is used, be certain there are no kinks.
If necessary for service, open the toe panel. Use a putty knife
to press on the toe panel Iock located at the center top of the
toe panel. PulI downward on the toe panel to open. Toe panel
is hinged at the bottom.
3. Open the shutoff valve in the gas supply line.
4. Test all connections by brushing on an approved noncorrosive
leak-detection
solution. Bubbles will show a leak. Correct any
leak found.
1. Using a 4" (10,2 cm) clamp, connect vent to exhaust outlet in
dryer. If connecting to existing vent, make sure the vent is
clean. The dryer vent must fit over the dryer exhaust outlet
and inside the exhaust hood. Make sure the vent is secured to
exhaust hood with a 4" (10.2 cm) clamp.
2. Move dryer into final position. Do not crush or kink vent. Make
sure dryer is level
3, Check to be sure there are no kinks in the flexible gas line,
For dryers using coin slides, use the adapter kit supplied with
the dryer.
10
Advertisement
