Applying Power Correctly; Starting Up - Magma PE6R4-I User Manual

CAUTION
This product is provided with a power supply that automatically
adjusts to input voltages between 100 to 240 Vac. A U.S. and
Canadian 125 V power supply cord is provided with this product. If
using this product outside of the U.S. or Canada, please use locally
available power supply cords

Applying Power Correctly

Starting Up:

You must apply power to the Magma expansion chassis
power up your computer. This will allow the higher numbered PCI buses
in the PCI bus hierarchy to be at a stable state when the host system
issues its master power-on bus reset. This will also allow the
configuration code to recognize the PCI bus hierarchy and any attached
devices.
There is an On/Off switch on the front panel,
as well as an LED indicator to indicate power
status. Verify that the green power indicator is
ON after pressing the button.
Windows Start Up
As your Windows computer starts up, you
will see a small message box pop-up in the
lower-right corner of the screen to alert you
that Windows has found new hardware.
Now you are all set. The system does not require any Magma drivers in
order to operate, unless you require Hot-Plug/Hot-Swap support (see
Chapter 4 for more details).
You may now proceed to
MAC Start Up
Apple MAC OS computers will boot up without any visible indicators that
the Expansion System is connected. Go to
Chapter 3 Verify Installation.
Chapter 3 Verify
Chapter 2 Hardware Installation
M A G M A
B EFORE you
U U
Installation.
7