Kenmore 29" Installation Instructions Manual page 17

REVERSE DOOR SWING
(OPTIONAL)
If your door is the Large Side-Swing Door, follow
steps 1-6.
j °J
If your door is the Super Wide Side-Swing Door,
follow steps 1-13.
NOTE: A magnetized screwdriver is helpful.
Large Side Swing Door
1.
Place towel on dryer
Lift door until top screws in cabinet are in large part of hinge
slot. Pull door forward off screws. Set door on top of dryer.
Remove top screws from dryer cabinet.
t-IF. Remove and transfer hinge
hole plugs
Use a small, flat-blade screwdriver to gently remove 4 hinge
hole plugs on left side of dryer cabinet. Insert plugs into hinge
holes on opposite side of dryer cabinet.
Place towel on top of dryer to avoid damaging the surface.
2.
Remove bottom screws
Open dryer door. Remove bottom screws from dryer cabinet
side of hinges. Loosen (do not remove) top screws from dryer
cabinet side of hinges.
dryer cabinet
NOTE: Two people may be needed to reinstall door.
Insert screws into bottom holes on left side of dryer cabinet.
Tighten screws halfway. Position door so large end of door
hinge slot is over screws. Slide door up so screws are in
bottom of slots. Tighten screws. Insert and tighten top
screws in hinges.
17