Barcode Scanner; Setting Up Barcode Reader - Opticon H22 User Manual

14. Barcode Scanner

The H-22 ships with either with a 1D laser barcode scanner or with a 2D imager module. In this
chapter, you can learn how to enable the scanning function and configure the scanner. chapter, you can learn how to enable the scanning function and configure the scanner.

14.1. Setting Up Barcode Reader

Enabling Barcode Reader
The barcode reader is disabled by default and must be activated before use. The barcode reader is disabled by default and must be activated before use.
1. Tap > Settings > System > Scanner Setting > Basic Settings. See below left.
2. Select the check box next to Enable barcode reader.
3. Select the check box next to Enable trigger key and select Top left, Side left, Top right or Side
right.
4. Tap OK to save and exit.
Figure 110. Barcode Settings
Setting to Multiple or Single Read Mode
Multiple read mode allows multiple barcodes to be read with just one triggering. Single read mode Multiple read mode allows multiple barcodes to be read with just one triggering. Single read mode
reads only one barcode during one triggering.
1. Tap > Settings > System > Scanner Setting > Read Options.
2. Select Single or Multiple from the drop down menu next to Read mode
3. Tap OK to save and exit.
Setting Good Read Notification
When the barcode scanner successfully decodes a barcode, you can set the H
a sound effect, vibration, both, or none.
1. Tap > Settings > System > Scanner Setting > Basic Settings.
2. Select the desired notification from the drop down menu under Good rea
3. Change the sound by selecting from the drop down menu under Sound.
4. Tap OK to save and exit.
er successfully decodes a barcode, you can set the H-22 to notify you with
Top left, Side left, Top right or Side
Figure 111. Read Notification . Read Notification
Read mode.
Good read notification.
102
imager module. In this
See below left.
. See above right.