Table of Contents
Advertisement
The H-21 comes equipped with a barcode scanner for reading barcodes.
Either with a 1D laser scanner or with a 2D camera module. In this chapter,
learn how to enable the barcode scanner and adjust the various settings.
Setting Up Barcode Reader
Enabling Barcode Reader
The barcode reader is disabled by default and must be activated before
use.
1.
Tap Start > Settings > System tab > Scanner Setting > Basic Settings.
2.
Select the check box next to Enable barcode reader.
3.
Select the check box next to Enable trigger key and select from Side
(Scan Left and Right Key), F1, or F2.
4.
Tap OK to save and exit.
Setting to Multiple or Single Read Mode
Multiple read mode allows multiple barcodes to be read with just one
triggering. Single read mode reads only one barcode during one triggering.
1.
Tap Start > Settings > System tab > Scanner Setting > Read Options.
2.
Select Single or Multiple from the drop down menu next to Read mode.
3.
Tap OK to save and exit.
Barcode Scanner
133
Advertisement
Table of Contents
