OnQ Technologies 925 Owner's Manual page 60

52 Model 925 Owner's Manual
For security zone bypasses and restores, the event log shows the zone name, whether the zone was
bypassed or restored, and the code number used:
9:00 AM
ZONE NAME
The code numbers shown as C1-C16, INS for the installer code, PCA for PC Access and PRG for
a programmed bypass or restore.
The event log records each zone that is tripped while it is armed. This does not mean that the
alarm has been activated, since the system may be disarmed before the entry delay expires. The
event log bottom line shows the zone name and "TRIPPED":
9:15 AM
ZONE NAME
For alarm activations, the event log shows the alarm type and the area (if area arming is being
used):
10:30 AM
ZONE NAME
For trouble conditions, the event log will show the zone name or specific trouble condition and
"TROUBLE":
10:56 AM
ZONE NAME
10:59 AM
BATTERY
For trouble restorations, the event log will show the zone name or specific trouble condition and
"TRBL RST":
11:57 AM
BATTERY
The system records each remote access. A remote phone access is when someone calls into the
system from an outside phone line. A remote phone access is also recorded if the system phones
out in response to an alarm and the called party enters a code. The event log displays the code
used to access the system and "REM ACCESS":
5/8
C10 BYPS
5/8
TRIPPED
5/8
BURG ALM
5/8
TROUBLE
5/8
TROUBLE
5/8
TRBL RST