OnQ Technologies 925 Owner's Manual page 32

24 Model 925 Owner's Manual
If you have a Master code, your code is valid in any area. If you are in Area 2, and wanted to arm
the system in the Away mode, simply press the Away key and enter your code. The system will
automatically arm Area 2. The security state of Area 1 will not change.
If you have a code that is only valid in Area 1, you will not be able to disarm or arm Area 2.
If you are in Area 1 and wish to disarm the security system in Area 2, the Model 925 will allow
you to disarm Area 2 from the keypad in Area 1 if you have a Master code or a code that is valid
for both areas.
From the top-level display or from the main menu, press the 2 (SEC) key on the keypad.
Press the 0 (OFF) key, the display will show:
DISARM
ENTER CODE:
Press the ' # ' (AREA) key, the display will show:
AREA:
ENTER AREA
The Area number can be entered followed by the ' # ' key, or the arrow keys may be used to scroll
through a list of areas. If the ' 0 ' key is pressed, then all areas will be selected.
Press the 2 key then the ' # ' key. You will then be prompted to enter your code. The display will
show:
DISARM AREA 2
ENTER CODE:
If the ' 0 ' (ALL) key had been selected, the display will show:
DISARM ALL AREAS
ENTER CODE:
As the four-digit code is entered, "X" characters are echoed after the "ENTER CODE:" prompt.
If the Master code or a valid code is entered, the keypad will beep one time and Area 2 will be
disarmed.
#=AREA
↓
0=ALL
#=AREA