4 = TEST (SYSTEM DIAGNOSTIC TEST)
The diagnostic test performed by the Model 925 allows you to check the status of the battery,
telephone, and security zone loop readings. The display is updated 3 times per second, although
the actual readings are taken 10 times per second. To enter the Test menu, from the Status menu,
press the 4 (TEST) key on the keypad.
The first display shows the current battery reading and the phone line status. A battery test is
initiated when the status mode is first entered. The new battery reading is updated ten seconds
later. The low battery limit is also displayed.
The phone status consists of two parts, separated by a "/". The first part shows the current phone
line state:
ONHK - ON HOOK
RING - RINGING
The second part shows how the Model 925 is currently using the phone line:
IDLE
- NOT USING THE PHONE LINE
LOCAL
- LOCAL ACCESS
REMOTE - REMOTE ACCESS
VOICE
- IN VOICE DIAL OUT MODE
EMGACC - ACCESS AFTER VOICE DIAL OUT
DCM
- IN DIGITAL COMMUNICATOR MODE
BATTERY: 203 (LIMIT 200)
PHONE:
Next, the display shows the A/D reading for the battery voltage, phone line voltage, AC power on
input, and the Two-Way Audio Module shutdown input:
BAT:
ACON: 200
OFFHK - OFF HOOK
DEAD - DEAD PHONE LINE
↓
ONHK/IDLE
225
PHONE: 140
SHUT:
200
OnQ Technologies, Inc. 49