Connecting The Receiver To The Mains - Sennheiser SKM 9000 Instruction Manual

Preparing the Digital 9000 system for use
EM9046
1 2 G H
32 | Digital 9000
If you have daisy chained your receivers (see page 29):
Connect the network sockets of the receivers in the order shown on
page 30.
EM9046
4 3
LAN UP
LAN DOWN

Connecting the receiver to the mains

CAUTION!
Damage to the device due to electric current!
If you connect the receiver to an unsuitable power supply, this
can cause damage to the device.
Use the supplied mains cable to connect the receiver to the
mains (100 to 240 V AC, 50 or 60 Hz).
Ensure a reliable mains ground connection of the receiver –
especially when you are using multi-outlet power strips or
extension cables.
To connect the receiver to the mains:
1
Set the ON/OFF switch
Connect the supplied mains cable to the 3-pin mains socket 2.
Plug the mains connector into the wall socket.
1
Set the ON/OFF switch
To disconnect the receiver from the mains:
1
Set the ON/OFF switch
All daisy chained signals are interrupted, i.e.:
– the antenna signals at the daisy chain outputs
– the booster supply voltage,
– the signal of the external word clock generator.
Pull out the mains connector from the wall socket to completely discon-
nect the receiver from the mains.
to position "0".
to position "1".
to position "0".
G and H,