Connecting Devices To The Output Sockets; Connecting Transmitters In A Network; Connecting The Mains Cable - Sennheiser SR 2000 IEM - 01-09 Instruction Manual

Putting the transmitter into operation
Stereo Transmitter SR 2000 IEM
FREQ RANGE-Dw FREQ RANGE-Dw FMO
790-865 mHz IC 2099A-SR20x0 IC 2099A-SR20x0
790-865 mHz
ART NO 503841
ART NO 627945 DESIGNED AND MADE IN GERMANY
DESIGNED AND MADE IN GERMANY
SER NO 2518100095 SER NO 251810043
Loop Out A
ANT B
BAL
B
+22dBu
MAX
L(I) R(II)
RF OUT ETHERNET RJ-45
Stereo Transmitter SR 2000 IEM
FREQ RANGE-Dw FMO
FREQ RANGE-Dw
IC 2099A-SR20x0
790-865 mHz 790-865 mHz IC 2099A-SR20x0
ART NO 503841
ART NO 627945
DESIGNED AND MADE IN GERMANY DESIGNED AND MADE IN GERMANY
SER NO 251810043 SER NO 2518100095
ANT B Loop Out A
BAL
+22dBu
MAX
L(I) R(II)
RF OUT ETHERNET RJ-45
CAUTION!
12
Connect the output socket
BAL AF IN R(II) of transmitter B.
Connect the output socket
BAL AF IN R(II) of transmitter C.
Repeat for the other transmitters.
The AF output sockets
only when the transmitter is switched on and powered.

Connecting devices to the output sockets

Use a suitable cable to connect the audio input of a device (e.g. a mixing console or an
additional SR 2000 IEM or SR 2050 IEM) to the output socket
or LOOP OUT BAL R (II)
The signal received from the AF input sockets
is actively buffered and then routed to the output sockets
and LOOP OUT BAL R(II)
transmitter is switched on and powered.

Connecting transmitters in a network

You can connect several transmitters in a network. The transmitters are remote controlled via
a PC running the "Wireless Systems
the quick and safe configuration of multi-channel systems.
The "Wireless Systems
website at www.sennheiser.com.
Connect a standard network cable (at least Cat 5) to the LAN socket
Connect your transmitters to an Ethernet switch.
Connect a PC to the Ethernet switch.
When a transmitter is properly connected to the Ethernet switch or the PC, the yellow
LED at the rear of the transmitter lights up.
For further information on network operation using the WSM, refer to page 30.

Connecting the mains cable

Damage due to electric current!
If you connect the transmitter to an unsuitable power supply, this can cause damage to the
device.
Use the supplied mains cable to connect the transmitter to the mains (100 to 240 V AC,
50 or 60 Hz).
Ensure a reliable mains ground connection of the transmitter – especially when you are
using multi-outlet power strips or extension cables.
LOOP OUT BAL R(II) of transmitter
LOOP OUT BAL R(II) of transmitter
LOOP OUT BAL L(I) and/or
(see also preceding chapter).
BAL AF IN L(I)
. The AF output sockets will therefore work only when the
Manager" (WSM) software. This software will assist in
Manager" (WSM) software can be downloaded from our
A to the input socket
B to the input socket
LOOP OUT BAL R(II) will work
LOOP OUT BAL L (I)
and BAL AF IN R(II)
LOOP OUT BAL L(I)
of the transmitter.
and/