Maintenance And Storage - Weslo Pursuit 720s User Manual

HOW TO SELECT KILOMETERS AND MILES
The console can display distance and speed in either
kilometers or miles. The letters ÒKPHÓ or ÒMPHÓ will
appear in the upper LCD display to show which unit
of measurement is selected.
To change the unit
of measurement,
first look under-
neath the console
and locate the
square hole. Look
inside the square

MAINTENANCE AND STORAGE

Tighten all parts of the exercise cycle regularly. The
exercise cycle can be cleaned with a soft, damp cloth.
To prevent damage to the console, keep liquids away
and keep the console out of direct sunlight.
CRANK ADJUSTMENT
If the arms of the
Crank (8) become
loose, they should
be tightened in
order to prevent
excessive wear.
Loosen the Hex
Crank Nuts (14)
on the left arm of
the Crank. Place
the tip of a stan-
dard screwdriver in one of the slots in the slotted
crank nut. Tap the screwdriver with a hammer to turn
the slotted crank nut counterclockwise until the arms
are no longer loose. Do not overtighten the slotted
crank nut. When the slotted crank nut is properly
tightened, tighten the Hex Crank Nuts.
HOW TO ADJUST THE REED SWITCH
If the console
does not dis-
39
play correct
feedback, the
reed switch
may need to
be adjusted.
To adjust the
reed switch,
you must first
remove the
Left Side
Shield (20).
Square Hole
Slotted
Crank Nut
14
8
13
20
8
13
13
72
hole and locate the small
switch on the printed circuit
board. Move the switch to
the opposite side to
change the unit of mea-
surement.
After changing the unit
of measurement, remove
one of the batteries from the console for about
five seconds and then reinsert it. This will reset
the console.
Using an adjustable wrench, turn the Left Pedal (39)
clockwise and remove it. Next, remove the indicated
M4 x 12mm Screws (72) and M4 x 38mm Self-tapping
Screws (13). Grasp both Side Shields and gently pull
them apart. Turn the left arm of the Crank (8) to the
position shown, and then carefully slide the Left Side
Shield forward and remove it.
61
42
43
View from the Front
With the left side shield removed, locate the Reed
Switch (42) (see the drawing below). Turn the Crank
(8) until the Magnet (61) is aligned with the Reed
Switch. Loosen but do not remove the M4 x 16mm
Screw (43). Slide the Reed Switch slightly closer to or
away from the Magnet. Retighten the Screw. Turn the
Crank for a moment. Repeat until the console displays
correct feedback. When the Reed Switch is correctly
adjusted, reattach the left side shield and the left
pedal.
BATTERY REPLACEMENT
If the console does not function properly, the batteries
should be replaced. See assembly step 3 on page 6.
11
Printed Circuit
Board
+
-
Switch
8