Storage And Trouble-Shooting - Weslo PURSUIT 640s User Manual

Speed, time,
distance or
calorie mode—
To select one
of these
modes for con-
tinuous display,
press the
mode button repeatedly. The mode indicators will
show which mode is selected. Make sure that the
scan mode is not selected.

STORAGE AND TROUBLE-SHOOTING

Inspect and tighten all parts of the exercise cycle
regularly. Replace any worn parts immediately.
The exercise cycle can be cleaned with a soft, damp
cloth. Avoid spilling liquid on the console. Keep the
console out of direct sunlight or the display may be
damaged. Remove the batteries when storing the
exercise cycle.
HOW TO STORE THE EXERCISE CYCLE
When the exer-
cise cycle is not in
use, it can be fold-
ed for compact
storage. Remove
the Spring Clip
(52) and then pull
out the "L" Pin
(56). Next, fold the
exercise cycle by
bringing the seat
and handlebars
52
toward one anoth-
er. Store the exer-
cise cycle indoors,
away from mois-
ture and dust.
BATTERY REPLACEMENT
If the console does not function properly, the batteries
should be replaced. See assembly step 5 on page 5.
In addition, make sure that the console wire is con-
nected to the reed switch wire.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. In order to adjust the
reed switch, the Left Side Shield (10) must be
removed. Using an adjustable spanner, turn the Left
Pedal (8) clockwise and remove it from the Crank
All manuals and user guides at all-guides.com
56
7
3. To reset the display, press the on/reset button.
4. To turn off the power, simply wait for about four min-
utes. Note: The monitor has an "auto-off" fea-
ture. If the pedals are not moved and the moni-
tor buttons are not pressed for four minutes,
the power will turn off automatically in order to
conserve the batteries.
(53). Remove the three M4 x 38mm Screws (40) and
the two M4 x 16mm Screws (7) from the Left Side
Shield. Make sure that the arm of the Crank is in the
position shown in the drawing above. Carefully slide
the Left Side Shield forward off the arm of the Crank
and remove it.
10
40
8
53
40
Next, locate the Reed Switch (49). Turn the Crank
(53) until the Magnet (4) is aligned with the Reed
Switch. Loosen but do not remove the M4 x 16mm
Screw (7). Slide the Reed Switch slightly closer to or
away from the Magnet. Retighten the Screw. Turn the
Crank for a moment. Repeat until the console dis-
plays correct feedback. When the Reed Switch is cor-
rectly adjusted, reattach the left side shield and pedal.
53
7
4
7
49