Troubleshooting; To Discharge The Bark Control Collar - Petsafe Bark Control Collar Operating Manual

The Bark Control Collar
does not beep.
My Bark Control Collar
beeps, but my dog keeps
barking (does not respond
to the Static Correction).
The Bark Control Collar
Indicator Light is fl ashing.

To Discharge the Bark Control Collar

Important: Avoid touching the Contact Points and Sensor Probe
unless the Bark Control Collar is completely discharged.
After battery removal, the Bark Control Collar retains some stored
energy and may activate 2 or 3 additional times. To completely discharge
the Bark Control Collar, slide the Sensor Probe across a table or hard
surface several times, until the Bark Control Collar stops beeping.

Troubleshooting

• Test the Bark Control Collar (see "To Test the Bark Control
Collar" section).
• If your Bark Control Collar does not beep during this test, try
the same test on a rougher surface.
• Ensure that the battery is properly installed.
• Replace the battery.
• If the Bark Control Collar still does not beep, contact the
Customer Care Center at 1-800-732-2677.
• Tighten the Bark Control Collar and/or trim your dog's hair
where the Contact Points touch his neck to ensure good skin
contact.
• Replace the battery.
• If your dog still does not respond, contact the Customer Care
Center at 1-800-732-2677.
• Replace the battery
www.petsafe.net 9