STEP 1 BATTERY ACTIVATION The battery module is installed in your UltraLight Sonic Bark Control unit. A removable protective film on the contact side of the battery prevents activation of the unit. Introduce your dog to the bark control unit as described in the training manual before removing the protective film.
Page 3
STEP 2 TEST UNIT Hold your finger over the speaker to muffle the sound when testing the unit. Blow across the microphone. The unit should emit a sharp sound. If you do not hear a tone – check the battery and repeat the test.
Page 4
STEP 4 ATTACH TO COLLAR Note: Do not place unit on your dog without reading the Training Manual. Collar material thickness should be approximately 1/16", and no wider than 1". Slide the collar under all four clips. Be sure the unit is placed in the center of the collar, opposite of the buckle, and fits snuggly against...
ADDITIONAL INFORMATION If you have additional questions regarding this product or training, U.S. customers may contact PetSafe Customer Support at 1-800-732-2677. The phones are staffed Monday – Friday 8AM till 7PM, Saturdays 9AM till 5PM, and Sundays 1PM till 5PM (Eastern Time).
Page 6
Radio Systems Corporation 10427 Electric Ave. Knoxville, TN 37932 Other helpful information may be found on our website: www.petsafe.net RETURNS If you are experiencing problems with your unit, our customer support department may be able to offer helpful advice. Should you decide to return your product, please include a brief description of the problem and ship to: RSC, Service Warehouse, 10427 Electric Ave., Knoxville, TN, 37932.
Need help?
Do you have a question about the ULTRALIGHT SONIC BARK CONTROL and is the answer not in the manual?
Questions and answers