® Thank you for choosing PetSafe . Our mission is to ensure your pet’s safety by providing you the tools and techniques to successfully train your pet. If you have any questions, please contact the Customer Care Center at 1-800-732-2677 or visit our website at www.petsafe.net.
• Non-metallic collar and 10-foot leash How the System Works The PetSafe Remote Trainer has been proven safe, comfortable, and effective for all pets over 8 pounds. This system assists you in controlling your pet without a leash in a range up to 100 yards.
Key Defi nitions Remote Transmitter: Transmits the radio signal to the Remote Transmitter Receiver Collar. Intensity Intensity Level Dial: Provides a choice of 10 different Level Dial levels of stimulation to enable you to match the level to Intensity your pet’s temperament. Level Transmitter Indicator Light: Indicates when any Transmitter...
3. Replace the battery door by positioning the bottom edge (1D), and snap the battery door into place. + -- + -- Transmitter Indicator Light – Function and Response Remote Transmitter Function Transmitter Indicator Light Response Any button is pressed Solid in color Low battery Flashes every 4 to 5 seconds www.petsafe.net...
® A replacement PetSafe battery (RFA-67) can be found at many retailers. Contact the Customer Care Center at 1-800-732-2677 or visit our web site at www.petsafe.net for a list of common retailers. Turning the Receiver Collar On and Off To turn the Receiver Collar on, press and release the On/Off Button. The Receiver Indicator Light will fl...
(3B). Note: It is sometimes necessary to trim the hair around the Contact Points to make sure that contact is consistent. 4. The PetSafe QuickFit™ Collar is designed so you can quickly Metal Buckle attach and remove the Receiver Collar from your dog while maintaining the desired fi...
5. The Receiver Collar should fi t snugly, yet loose enough to allow one fi nger to fi t under the strap (3F). Allow your dog to wear the collar for several minutes, then recheck the fi t. Check the fi t again as your dog becomes more comfortable with the Receiver Collar.
Remote Transmitter. If the Remote Transmitter times out, release the Stimulation Button and press it again to deliver stimulation. Note: For either one or both of these training methods to be effective, they must be used consistently along with the command you are trying to teach your pet. www.petsafe.net...
Training Guide General Tips • Eliminate one misbehavior or teach one obedience command at a time. If you move too fast with the training, your pet may become confused. • Be consistent. Give your pet a tone or stimulation with each misbehavior. •...
Praise your pet when he returns to you. 11. Use your leash to prevent your pet from running past you. If your pet manages to run past you, repeat Steps 3 through 8. www.petsafe.net...
The “Stay” Command 1. Put a separate, non-metallic collar on your pet’s neck ABOVE the Receiver Collar, and attach a 10-foot leash. Note: Be sure the extra collar does not put pressure on the Contact Points. 2. Put your pet on his bed. Hold your leash in one hand and the Remote Transmitter in the other. 3.
5. If your pet ignores the stimulation, increase the Intensity Level by 1. 6. Continue to watch your pet, as he may choose another area to dig. 7. Do not allow your pet in the yard unsupervised until he has completely stopped digging. www.petsafe.net...
Chasing Chasing is an instinctive behavior stimulated by moving objects. Some dogs have a particularly strong desire to chase that can put them in harm’s way and leave you helpless. Never allow your dog off the leash or out of a contained area until he has learned the “Come” command, regardless of the distraction.
4. Immediately release the button once your dog stops barking and praise him. 5. If your dog ignores the stimulation and continues to bark, increase the Intensity Level by 1 and repeat the process. 6. Practice this exercise in different areas using different situations that would cause your dog to bark. www.petsafe.net...
How old does my pet have to be Your pet should be able to recognize basic obedience before using the PetSafe Remote commands such as “Sit” or “Stay”. The Receiver Collar may Trainer? be too large for pets under 8 pounds.
• There is no tone associated with this button. An audible not beep when I press the tone is emitted by the Receiver Collar only when the Tone Stimulation Button. Button is pressed, or when pairing the Remote Transmitter with the Receiver Collar. www.petsafe.net...
To Pair the Remote Transmitter and Receiver Collar If your Receiver Collar does not beep when the Tone Button of the Remote Transmitter is pressed, or if you feel the Receiver Collar is not responding to the Remote Transmitter: 1. With the Receiver Collar off your pet, turn the Receiver Collar on. 2.
Product. Buyer assumes all risks and liability from the use of this Product. 5. Modifi cation of Terms and Conditions Radio Systems Corporation reserves the right to change the terms, conditions and notices under which this Product is offered. www.petsafe.net...
Need help?
Do you have a question about the Big/Little Dog Remote Trainer and is the answer not in the manual?
Questions and answers