Regular Maintenance; To Test The Bark Control Collar; Accessories - Petsafe Bark Control Collar Operating Manual

You should notice a reduction in your dog's barking within the fi rst couple of days that he wears
the Bark Control Collar. At this point, it is important to remember the learning process is still not
complete. Dogs will "test" this new learning experience and will increase their attempts to bark.
This usually occurs during the second week a dog wears the Bark Control Collar. If this does occur,
remain consistent and do not alter your use of the Bark Control Collar. You must place the Bark
Control Collar on your dog in every situation when you expect him to be quiet. If your dog is not
wearing the Bark Control Collar, he may resume barking and his learning would suffer a setback.
____________________________________________________________________

Regular Maintenance

• Check Contact Points for tightness weekly
Note: Do not adjust the factory preset Sensor Probe.
• Clean Contact Points with alcohol weekly
Note: Remove the battery and discharge the Bark Control Collar before
touching the Contact Points.
• Check your dog's neck for irritation and wash neck weekly.
____________________________________________________________________

To Test the Bark Control Collar

Slide the Sensor Probe across a rough surface for at least 10 inches. The
Bark Control Collar should beep. If your Bark Control Collar doesn't
beep during this test, see "The Bark Control Collar does not beep" in the
"Troubleshooting" section, and continue with the second step.
_____________________________________________________________________________________

Accessories

To purchase additional accessories for your PetSafe
Care Center at 1-800-732-2677 or visit our website at www.petsafe.net to locate a retailer near you.
Component
Battery - two pack
Replacement Collar
Accessory Pack (Extra Contact Points,
washers, and battery)
Bark Control Video - VHS
® Bark Control Collar
Part Number
RFA-67D-11
RFA-68
RFA-118
RFA-149
www.petsafe.net
™ , contact the Customer
7