Receiving Volume; Ring Tone/Volume - NEC Dterm Cordless II User Manual

Muting
1. Press MUTE during conversation.
The 'TALK' icon blinks and the voice through the microphone is muted.
>
2. Press MUTE again to cancel the muted condition. (Finishing the conversation also cancels
the mute condition.)
The 'TALK' icon stops blinking.
>
Conferencing
This feature allows the user to set up a 3-party conference.
1. During a conversation, press CONF.
2. Dial the number for the second conference party.
3. Press CONF again to establish a 3-party conference.

Receiving Volume

1. During a conversation, press R/VOL to change the ear speaker volume setting.
The telephone has four receiver volume levels: Low, Medium, High, Maximum.
>
2. Continue to press R/VOL until the desired volume is selected.
When you hang up, the telephone retains the last selected volume.
>

Ring Tone/Volume

In standby mode, press R/VOL to change the ring tone and volume.
In standby mode, press R/VOL.
The selected tone and volume rings for about two seconds. The display shows ring
>
tone: Type A – High/Low, Type B – High/Low, Type C – High/Low, OFF – Vibrate.
If R/VOL is pressed while the ringer tone is sounded, the handset stops ringing and goes to
the next tone setting.
The LCD display disappears after the selected tone/volume rings for about two
>
seconds.
4