Chuck Removal; Changing Jaw Set - Grizzly G0602 Owner's Manual

Chuck Removal

Tools Needed:
Chuck Wrenches ............................................... 2
Hex Wrench 5mm .............................................. 1
To remove the chuck:
1.
DISCONNECT LATHE FROM POWER!
2.
Use an appropriate device to protect the ways
and support the chuck (refer to Installation &
Removal Devices on Page 26).
3. Remove the cap screws and chuck locks
(see Figure 24).
Chuck Lock
Figure 24. Location of chuck lock and cap
screws.
4.
Insert the chuck wrenches, as shown in
Figure 25, then while holding the spindle,
unthread the chuck in a counterclockwise
direction.
Figure 25. Location to insert chuck keys when
removing chuck.
5. Support the chuck, unscrew it, and remove.
-28-
Qty
Cap Screw
Insert Keys
Here

Changing Jaw Set

Tools Needed:
Chuck Wrench ................................................... 1
The 3-jaw scroll chuck included with the lathe fea-
tures inside and outside hardened steel jaw sets
(see Figure 26), which move in unison to center
a concentric workpiece.
When installing the jaws, it is important to make
sure they are installed correctly. Incorrect installa-
tion will result in jaws that do not converge evenly
and are unable to securely clamp a workpiece.
Outside
Set
Figure 26. Chuck and jaw selection.
Jaws are numbered from 1–3 (see Figure 27).
They are designed to be installed in numerical
order in the jaw guides so they will hold a concen-
tric workpiece evenly.
Jaw
Guides
Figure 27. Jaw guide and jaw numbers.
Model G0602/G0752 (Mfg. Since 11/12)
Qty
Inside
Set
Jaw Numbers