Installing Your Heater - Williams 0656542.9 Owner's Manual

Installing Your Heater

Unpack Your Unvented Gas Heater
The heater is shipped assembled. The cabinet must be removed
for the heater installation.
1. Open carton and carefully lift out heater.
2. Stand heater upright.
3. Hardware included with heater:
(2) metal mounting brackets
(4) screws
(4) plastic anchors
(1) mounting bracket paper template
Locating Unvented Gas Heater
Consider the following points before attempting to install the
heater:
1. This heater is designed to be mounted on a wall. It can
also be located on the floor, away from the wall, using an
optional floor mounting stand.
2. Select a location for the heater that will provide exposure
of the radiant surface to the room, but will not be subjected
to accidental contact. Adequate clearance must be
available around the air opening.
3. Be sure to read the section "Provisions for Adequate
Combustion and Ventilation Air" requirements before
Clearances
Adequate clearances must be provided for accessibility for
purposes of servicing and proper operation.
Wall Mounted
1. Minimum clearance to adjacent walls is 6".
2. Minimum clearance to floor (top surface of carpeting, tile
or other combustible material) is 6".
3. Minimum clearance between the heater and ceiling is
36".
8
4. Properly dispose of shipping material.
Check the burner rating plate, located inside the cabinet on the
bottom, to make sure your heater is equipped to operate on the
type of gas available (either Natural or L.P. Gas). DO NOT
convert the heater from Natural Gas to L.P. Gas or from L.P. Gas
to Natural Gas.
deciding where you install this heater. The heater must
have enough fresh air suitable for proper combustion.
4. For proper combustion of the heater, you may need to
provide one or more fresh air openings to the room where
the heater is located.
5. This heater creates warm air currents that move heat to
wall surfaces next to heater. Installing the heater next to
vinyl or cloth wall coverings or operating heater where
impurities in the air (such as tobacco smoke) exist, may
discolor walls.
Floor Mounted With Optional Base
1. Minimum clearance between the heater and adjacent
walls is 6".
2. Minimum clearance between the heater and ceiling is
36".
NOTE