Installing And Operating Your Blower Accessory - Williams 0656542.9 Owner's Manual

Installing and Operating Your Blower Accessory

Blower Accessory 2205 and 2206
1. Disconnect unit from gas supply and wall before installing
blower.
2. Remove back plate from unit by unscrewing four (4)
screws. Retain four (4) screws back plate for installation
of blower. Discard back plate.
3. Install blower as shown in the illustration. Use the four (4)
screws retained to mount blower to the back panel.
4. The blower assembly is equipped with a three-prong, 7-foot power cord. Use a standard three-hole, grounded outlet. If an
extension cord is needed, use a standard three- prong grounded cord with a three-hole receptacle.
5. Blower Operation for model 2205, - turn thermostat switch to "ON" position. Turn heater on. Blower will cycle "ON" or "OFF" as
the thermostat heats and cools to desired temperature. Turn the heater "OFF" and the blower will automatically turn off, or switch
the blower ON/OFF switch to the "OFF" position.
To operate model 2206, turn switch to "ON" or "OFF" position as desired.
This unit must be grounded for your protection against electrical shock.
Service and Orders – 25
25