Table of Contents
Advertisement
INSTALLING YOUR FURNACE
Optional Accessory Installation
SIDE OUTLET MODEL 6701
REAR OUTLET MODEL 6801
SHORT REAR OUTLET MODEL 6802
CAUTION: Use only Boots and Grilles provided by
the manufacturer.
CLEARANCES
IMPORTANT - Carefully follow all measurements and clear-
ances given to ensure proper installation.
When SIDE OUTLET MODEL 6701 is used, the furnace
casing must be a minimum of 4 inches from an adjacent
side wall (except may be 3/4" minimum when 1-WAY
FRONT DIFFUSING GRILLE is used). See Figure 26
and Figure 27.
When REAR OUTLET MODEL 6801 or SHORT REAR
OUTLET MODEL 6802 is used, the furnace casing must
be a minimum of 12 inches from an adjacent side wall as
shown on Page 8, Figure 3D.
CUT CASING OPENING(S)
Before setting the furnace into position, cut a 5 x 7 inch
rectangular opening for Side Register, or 7 x 11 inch
opening for a Hear Outlet Register where marked on the
furnace casing. Cut carefully as edges must be straight
and smooth. See Page. 13, Figure 13.
CUT WALL OPENING(S)
Make an opening(s) in the wall(s) for a Side and/or a Rear
Outlet Register. See Figure 25.
INSTALL PLASTERGROUNDS
Install plastergrounds as shown in Figure 27 and Figure 28.
Flanges of plastergrounds extend the normal thickness of
plaster. If "DRYWALL" or other thin material, flanges must
be trimmed off flush with wall surface.
20
MAGNUM FORSAIRE COUNTERFLOW TOP VENT GAS WALL HEATER
FIGURE 25 - CUT WALL OPENING
FIGURE 26
FIGURE 27
FIGURE 28
Advertisement
Table of Contents
