Power Supply Cord - Generac Power Systems 02010-2, 04164-3 Installation And Owner's Manual

2.7.6 POWER SUPPLY CORD

The power supply cord must comply with all appli-
cable codes, standards and regulations. It must be
large enough to handle the full amperage to which it
will be subjected.
Figure 2.18 – Transfer Switch Isolation Method
PRIMEPACT
Maintenance Schedule Every 8 hours Every 25 hours Every 100 hours
or before use or 3 months or once a year
Check engine oil level
Change oil
Change oil filter
Clean & re-oil foam pre cleaner
Clean air intake
Clean & reset spark plugs
Replace fuel filter
Inspect battery posts & cables
"Exercise" generator
RV Service Locator 1-800-333-1322 • www.guardiangenerators.com
Figure 2.19 – Installation With Isolation Receptacle
PRIMEPACT
Every 8 hours Every 25 hours Every 100 hours
Maintenance Schedule or before use or 3 months or once a year
Check engine oil level
Change oil
Change oil filter
Clean & re-oil foam pre cleaner
Clean air intake
Clean & reset spark plugs
Replace fuel filter
Inspect battery posts & cables
"Exercise" generator
RV Service Locator 1-800-333-1322 • www.guardiangenerators.com
Section 2 – Installation
Recreational Vehicle Generator
2.7.7 GROUND FAULT CIRCUIT INTERRUPTERS
The National Electrical Code (NFPA 70, 551-7)
requires that ground fault circuit interrupters (GFCIs)
on all external and some internal electrical recepta-
cles be installed. Contact the manufacturer or dealer
for recommendations.
33