Friedrich WallMaster WS08 Installation And Operation Manual
Thru-the-wall air conditioners and heat pumps
Hide thumbs
Also See for WallMaster WS08:
- Installation & operation instructions (49 pages) ,
- Installation and operation manual (43 pages) ,
- Installation & operation manual (49 pages)
Related Manuals for Friedrich WallMaster WS08
Summary of Contents for Friedrich WallMaster WS08
- Page 1 Thru-the-wall Air Conditioners and Heat Pumps 115-Volt: WS08, WS10, WS12 230-Volt: WS10, WS13, WS15, WE10, WE13, WE15, WY09, WY12 920-007-16 (5 -10)
-
Page 2: Table Of Contents
Your Safety and the safety of others ............................3 General Information Economizing Tips ..................................Electrical Data ....................................3 Introduction How to operate your Friedrich room air conditioner ........................4 To start unit ....................................4 To set mode of operation ................................4 To adjust temperature ...................................4 To adjust fan speed... -
Page 3: Your Safety And The Safety Of Others
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what will happen if 10. Keep your Friedrich unit clean. Use a vacuum cleaner the instructions are not followed. -
Page 4: How To Operate Your Friedrich Room Air Conditioner
How to operate your Friedrich room air con di tion er To start unit To activate Smart Fan (WY/WE heat-cool models) r i a o i t i s i r s n i l l a t , e l Press the Smart Fan button to activate the Smart Fan. -
Page 5: Automatic Component Protection
Digital Control Panels Using the remote control To start unit (See Figure 3, page 6) 1 POWER - Press the Power button once. The unit will automatically start in the mode and fan speed it was last left on. To set mode of operation 2 COOL - Press the Cool button to automatically switch the operat- Power ing mode to COOL. -
Page 6: How To Clean The Air Filter
Timer On/Off function will not work. Figure 3 Additional RC1 wireless remote controls can be purchased from your Friedrich dealer. WY/WE heat-cool model remote control How to clean the air fi lter Your Friedrich room air conditioner is equipped with a Permafoam reusable air fi lter which is not affected by washing. -
Page 7: How To Change Airfow Direction
CIRCUIT PROTECTION - Before installing or relocating your removing the inner weather panel (see Figure 5). The plugs must be Friedrich Room Air Conditioner, check the amp rating of the circuit attached before the DECORATIVE FRONT frame is installed. breaker or "TIME-DELAY" fuse. Refer to the nameplate located on... -
Page 8: Never Use An Extension Cord
If the unit operates, but won’t cool, determine if the controls are properly set. Set the thermost to a cooler position in order to check All Friedrich room air conditioners are shipped from the factory with control settings. Check the filter and clean it thoroughly, if needed. -
Page 9: Installation Instructions For Wsd Sleeve
The compressor will stop and the fan will continue to run. The electric heat will be The decorative front of your Friedrich room air conditioner, as well turned on to continue warming the room while the outdoor as the complete cabinet, may be cleaned with warm water and mild air defrost the outdoor coil. -
Page 10: Installation Requirements
Installation requirements Sleeve installation STEP 1 The WSD SLEEVE should be positioned so that the STEP 1 After unpacking the WSD SLEEVE from the carton, remove DRAIN EXTENSION extends a minimum of " beyond the FRONT PANEL. Place the WSD SLEEVE in the wall the OUTSIDE WALL (See Figure 7). - Page 11 Remove the rear WEATHER PANEL. Reverse grille. Tilt it down toward you, lift up and out of the bottom retaining Place lower edge into sleeve tab (Friedrich logo facing out). snaps. Install the decorative front frame in place over the Aligns slots with screw holes.
-
Page 12: Ws, We And Wy Models Installation
STEP 3 Slide the tubing over the drain nipple. the walls can use the Friedrich Interior Drain Kit (Accessory #IDK). If the chassis must be removed from the sleeve for service, remove This kit is designed for installation in the bottom of the sleeve the clamped drain hose before sliding the chassis out of the sleeve. -
Page 13: Warranty
FIRST YEAR ANY PART: If any part supplied by FRIEDRICH fails because of a defect in workmanship or material within twelve months from date of original purchase, FRIEDRICH will repair the product at no charge, provided room air conditioner is reasonably accessible for service.