Loading the Paper
Turn on the power.
Cut the tip of the paper straight across.
Unused Paper can be inserted as is.
(See figure on right)
Open the paper cover.
Push the tip of the paper into the inlet at the bottom of the paper
holder, until the auto-loader catches it and feeds about 10cm of it
through the paper cutter.
NOTE
Load the paper in an area protected from direct sunlight.
HINT
•
Place the paper on the cover to make feeding easier.
The printing surface
is the outside of the
thermal paper roll.
Insertion Slot
Keep pressing the paper feed switch until the paper feeds straight
and smoothly.
HINT
•
When the paper is set correctly, the OFFLINE lamp stops blinking
and stays on to indicate the printer is still in OFFLINE mode.
•
When the paper is about to run out, red lines appear on both sides
of the paper.
- 14 -
Paper
Insert
direction