8.1
Seat Depth Adjustment - 35 mm depth adjustment
The individual fitting of the seating allows the seat depth to be adjusted by 35 mm (1"). The
adjustment, which is usually only done once, is carried out as follows. You will need a large cross-
headed screwdriver and a 13 mm spanner.
• Prise off plastic cap at point A, unscrew and remove the screw and nut, repeat each side.
• Move the backrest mounting bracket backwards to the extended position. Replace the nut and
screw into the selected hole and firmly fasten, replace plastic cap, repeat each side.
8.2
Adjusting the backrest
The backrest angle can be adjusted from 90° rearwards through 12° The adjustment, which is
normally only required to be done once, is carried out in the following sequence (see diagram) with
the aid of the 13 mm spanner and the cross-headed screwdriver. Do the same adjustment for both
sides.
40