Appendix A. Specifications; Technical Specifications - M-Audio STUDIOPHILE DSM3 User Manual

appendix a
Specifications

Technical Specifications

DSM3 Specifications
LF Driver (2) 6.5-inch inverted anodized aluminum cone woofers with cone edge reinforcement
35mm voice coil with symmetrical force motor and flux stabilization rings
HF Driver 1-inch soft teteron dome tweeter with neodymium magnet and ferrofluid cooling
Frequency Response 45 Hz–27 kHz +/–3 dB
Crossover 2.7 kHz Linkwitz-Riley 24 dB/octave
Max SPL @ 1 meter 111 dB maximum peak SPL @ 1m for 1 unit (117 dB maximum peak per pair)
Input Sensitivity +4 dBu pink noise input with Trim level set to 0 dB yields 90 dB @ 1m
LF power amplifier 100 W (1% THD into 6 Ohms)
HF power amplifier 80 W (0.5% THD into 6 Ohms)
THD+N <0.05% (10 W into 6 Ohms)
Soft Limit feature Independent anti-clipping limiters: tweeter limited to 0.5% THD, woofer limited to 5% THD
Power Requirements User selectable for 90–130V~ 50/60 Hz or 180–264V~ 50/60 Hz
DSP 36-bit, 192 kHz processing
Protection Over current, over temperature, turn-on/off transient, subsonic filter
Analog Inputs XLR balanced (20 kOhms) and 1/4-inch TRS balanced (20kOhms)
Digital Inputs S/PDIF In and Thru (75 Ohms) and AES/EBU (110 Ohms);
built-in phase-lock loop (PLL) to reclock incoming bitstreams with low jitter (<250 psec p-p);
44.1, 48, 88.2, 96, 176.4, 192 kHz sample rates
Indicator RGB LED
Appendix A: Specifications 17