Table of Contents
Advertisement
Installing a Fuse
A 2.5 Amp fuse is required for both the
100–120V and the 220–240V settings.
Make sure to use a fuse rated at 2.5 Amps.
Do not use fuses of any other rating, or you
risk damage to the unit
To change the fuse:
Turn off power to the speaker and disconnect
1
the AC power cord.
Use a small screwdriver to remove the fuse
2
holder.
Fuse
holder
Fuse holder
Remove the currently installed fuse.
3
Install the new fuse in the fuse holder.
4
Replace the fuse holder so that it clicks into
5
place.
Connecting Power
To connect power to the speakers:
Make sure you have set the Voltage Selector
1
and installed the proper fuse before proceeding.
(See “Setting the Voltage” on page 9 for details.)
Connect the included AC power cord to the
2
AC connector on the back panel of each speaker
(one power cord is included with each speaker).
AC
connector
AC connector
Connect the other end of the AC power cord
3
to your power source.
Power Up and Power Down
Always power up your speaker system last (al-
lowing mixers, recorders and other devices to
fully power up first).
Conversely, always mute (or power off) your
speaker system first, before powering off other
devices in your studio.
Page 10
Hide quick links:
Advertisement
Table of Contents
