Table of Contents
Advertisement
32 Service Search
4.1.4 Configuring actuator settings
4. Select the Goto the position option. Then the antenna
will turn toward your selected satellite calculating its
position.
5. If the receiving quality, which is displayed on the right
bottom on the screen, is not good, then tune the antenna
finely with the options of the Move menu. The changed
position is automatically saved. At this time you had
better check the receiving quality of every transponder
and choose the best one at the Transponder (or Frequency)
option. It will be helpful to your fine tuning.
If you have connected the digital receiver with your antenna
actuator, you should configure actuator settings.
NOTE
Ensure that the antenna is properly installed and the digital re-
ceiver is correctly connected with the antenna actuator before
going any further. For how to connect them, refer to § 2.4.
1. Press the
V
tor then will start to rotate the antenna to the east as long
as it can. Here the
To configure actuator settings,
select the Installation
Setting menu.
At first you have to set the east
limit and west limit of the actua-
tor by performing the following
steps:
button at the East Limit option; the actua-
button stands for the east.
V
Dish
Advertisement
Table of Contents
