Choose The Water Level - Simpson Washing Machine User Manual

CHOOSE THE WASH CHOICE

CHOOSE THE WATER LEVEL

If the water level you have is high and you wish to reduce this level for the following Deep Rinse cycle or for
your next wash program, turn the Water Level knob to low level when the machine is running and NOT in
pause mode. The washing machine will use this new lower level for next fill of water.
NOTE:
Flood diagnostic is explained on page 19. You should refer to this if you have water pouring onto the floor
and WASH, RINSE and SPIN lights are flashing.
The WASH CHOICE button lets you have an influence on the wash time
of the selected programe. You can choose from three settings:
- for very dirty clothes eg overalls or muddy sports clothes.
- for your normal everyday wash of cottons, sheets etc.
- for lightly soiled clothes and delicate items.
Press the WASH CHOICE button if you want to increase or decrease the
wash time.
For the same wash programe, Extra Dirty will have a longer wash time than
Regular, and Regular a longer wash time than Light & Fast.
1. Choose the water level by turning WATER LEVEL knob.
You can select:
(or any level in between)
2. Use only the amount of water you need for the wash load.
3. If you want to add more water after wash cycle has started, press the
START/PAUSE button and turn the WATER LEVEL knob to the new
higher level that you want, press the START/PAUSE button again
to continue your wash cycle.
The machine will add water up to the new level selected and continue
the wash program.