3.4.2 Steps
1. Configuring the HG520b
Follow the steps described as follows:
(1)
Log in to the Web configuration page. For the procedure,
refer to "2.3 Establishing Configuration Environment."
(2)
Select Basic > WAN Setting in the navigation tree to
display the WAN configuration page.
(3)
In the WAN configuration page, select the PVC that needs to
be configured.
(4)
Set Mode to Routing.
(5)
Select Obtain an IP Address Automatically or Static IP
Address. Configure the relevant parameters according to
the values in the Table 3-4.
(6)
Click Submit.
2. Configuring Your Computer
Configure the network card for your computer, to enable the computer
to automatically obtain information such as the IP address and the
gateway.
3.5 Configuring the RFC2684B Mode
Configuring the RFC2684B mode is similar to configuring the mode
IPoA. For details, refer to 3.4 "Configuring the IPoA Mode."
3.6 Configuring the PPPoE mode
In the PPPoE mode, the HG520b uses the embedded PPP dial-up
software for dialing.
Configuring the PPPoE mode is similar to configuring the PPPoE mode.
The only difference is that you have to select PPPoE in the
Encapsulation to configure PPPoE. For details, refer to 3.3
"Configuring the PPPoA Mode."
14