Table of Contents
Advertisement
NOTE: When only one unit of the DVR is connected to a computer or LAN, you can freely assign
an IP address for the DVR. For example, there is a range of DVR IP addresses from
192.168.0.1 to 192.168.0.255. You can pick one for use from the range of the IP. It's not
necessary to set MASK and GATEWAY; leave the settings as default.
When a DVR is connected to a WAN, you must acquire a unique, permanent IP address
and correctly configure the MASK and GATEWAY settings according to your network
architecture. If you have any questions regarding those settings, please contact a qualified
MIS professional or your ISP.
NOTE: When connecting to a network, each connected DVR must be assigned a unique IP, which
must be in the same class type as your network address. IP addresses are written as four
sets of numbers separated by periods; for example, 192.168.0.1 Therefore, if the connected
network is identified as Class C, for example, the first three sets of numbers of the DVR IP
address must be the same as the network address. If the connected network is identified
as Class B, the first two sets of numbers of the DVR IP address must be the same as the
network address. If you have any questions regarding these settings, please contact a
qualified MIS professional or your ISP.
12.3 TCP/IP Communication Software
Follow the instructions below to install the TCP/IP communication program into your computer.
Click the Start Menu from your computer, and point to the Settings/Control panel.
70
Advertisement
Table of Contents
