IDVIEW IV-110CD-SN Installation And Operating Manual page 39

PRE- ALARM:
This option determines that images prior to an alarm occurs will be recorded in the hard-disk drive.
When an alarm is triggered the device will record the image prior to the alarm for 5 seconds. (
)
fields/sec
ON: Enables this function.
OFF: Disables this function.
NOTE: If the device is already under recording mode before alarm occur, the pre-alarm
recording would not take effect.
MOTION SETTING:
The motion detection function is convenient for the people without alarm trigger input, but also can
used with alarm trigger input at the same time. If this function is enabled, the object movement would
trigger the alarm recording just like the outside trigger signal. Before using the motion detection
function, please turn the ENABLE option as ON, and set the SENSITIVITY (1 ~ 5) to a suitable value.
NOTE: The MOTION ENABLE option is not allowed set to ON when MULTIPLEXER option
( in REC SETTING page ) is set to ON, it is because the motion detection function is
for single camera only.
MOTION SETTING
MOTION ENABLE
SENSITIVITY
REGION
MAIN PAGE
ENABLE MOTION DETECTION
MOTION ENABLE:
This option enables / disables the motion detection.
ON: Enables the motion detection.
OFF: Disables the s motion detection.
SENSITIVITY:
This option allows users to set the motion sensitivity.
1 is the most sensitive setting. 5 is the least sensitive setting.
REGION
This option allows users to set the motion region.
: ON
: 3
: SET
37
SET MOTION REGION
( 30 , 30 ) – ( 90 , 70 )
20