Table of Contents
Advertisement
10.1.4 Change the Record & Timer Properties Via the Network
Follow the instructions below to reconfigure the record and schedule recording settings via the network.
A.
Set the regular record settings
1. When in the single –device mode, click
above)
2. Select a desired recording rate and Quality from the corresponding drop-down list
3. Click the OK tag to proceed.
Set the Alarm record settings
1. When in the single –device mode, click
above)
2. Set the Alarm Setting to ON to enable the drop-down list in the ALARM SETTING area.
2. Select a desired recording rate and Quality from the corresponding drop-down list.
4. Click the OK tag to proceed.
Set the Record Schedule
1. When in the single –device mode, click
above)
2. Set the Record Schedule to ON to enable the Record Schedule setting area.
3. Click the Time-Period button to set the schedule for recording for each day. Go to both the Start Time &
End Time boxes, enter a specific Hour: Minute and click Add button to add to the Record List.
4. When all required settings are completed, click OK to proceed.
B.
to enter the SETUP page. (See the sample screen as in A
to enter the SETUP page. (See the sample screen as in A
to enter the SETUP page. (See the sample screen as in B
63
Advertisement
Table of Contents
